新闻资讯

燃气热风炉正常炉况的标志!

2019-12-11 来源:http://www.zhongyanjixie.com 发布人:众焱小编 浏览量:
[导读]:  煤气炉正常使用,其操作状态是一种相对稳定的形式,整个设备的温度以及燃烧效率可以充分利用的,除此之外,每个人的操作设备,更加关注正常
  煤气炉正常使用,其操作状态是一种相对稳定的形式,整个设备的温度以及燃烧效率可以充分利用的,除此之外,每个人的操作设备,更加关注正常操作标志,下面给你看。
  The gas furnace is in normal use, and its operation state is a relatively stable form. The temperature and combustion efficiency of the whole equipment can be fully utilized. In addition, everyone's operation of the equipment pays more attention to the normal operation signs. Let me show you below.
  (1)燃气热风炉风口光亮,焦炭活跃,风口前无原料或炉渣,风口损坏少;
  (1) the tuyere of the gas hot blast stove is bright, the coke is active, there is no raw material or slag in front of the tuyere, and the tuyere is less damaged;
  炉温充足,炉渣流动良好,炉渣不带铁,渣沟不形成厚壳,炉渣口烧得少;
  The furnace temperature is sufficient, the slag flows well, the slag does not carry iron, the slag trench does not form thick shell, and the slag mouth burns less;
  (3)铁水白色光亮,物理热高,成分相对稳定;
  (3) the molten iron is white and bright, with high physical heat and relatively stable composition;
  (4)炉顶温度有规律波动;
  (4) the top temperature fluctuates regularly;
  (5)风压稳定,风量略有波动,曲线呈圆形,渗透率指数变化平稳,无锯齿状;
  (5) the wind pressure is stable, the air volume fluctuates slightly, the curve is round, the permeability index changes smoothly, and there is no sawtooth;
  (6)顶压稳定,上下峰不频繁;
  (6) the top pressure is stable and the peaks are not frequent;
  (7)燃气热风炉进料均匀,无滞止、无塌陷、无快、慢现象,双测标度基本相同,物料标度曲线整齐,倾角稳定;
  (7) the feed of gas hot blast stove is uniform, without stagnation, collapse, fast or slow phenomenon, the double scale is basically the same, the material scale curve is neat, and the inclination angle is stable;
热风炉生产厂家
  (8)炉喉CO2曲线接近对称双峰形,峰谷相对开阔,峰在2点或3点;边缘与数值相近或略高,CO2%的平均值更高。
  (8) the CO2 curve of the furnace throat is close to symmetrical bimodal shape, the peak valley is relatively open, the peak is at 2 or 3 points; the edge is close to or slightly higher than the value, and the average value of CO2% is higher.
  (9)炉膛温度、炉体温度、炉底温度变化不大;
  (9) furnace temperature, furnace body temperature and furnace bottom temperature have little change;
  (10)炉喉、炉腰、炉身冷却水温差符合要求。
  (10) the temperature difference of cooling water in the throat, waist and body of the furnace shall meet the requirements.
  以上是正常的煤气炉炉条件分析,使用加热设备工作时,必须注意掌握正确的设备操作方法,确保炉条件能满足使用的要求,和一些处理标志是反映设备的使用,你可以把更多的注意在日常使用的过程中。
  The above is the analysis of normal gas furnace conditions. When using the heating equipment, you must pay attention to the correct equipment operation method to ensure that the furnace conditions can meet the requirements of use, and some processing signs reflect the use of the equipment. You can pay more attention to the daily use process.
返回顶部

版权所有©山东众焱机械有限公司 备案号:鲁ICP备19005667号-1 服务热线:18005415007 流量统计: